Identify a Gas Water Heater Not Heating

Identify a Gas Water Heater Not Heating

A overwhelming majority of the water heaters Water Heater Repair San Jose receives repair requests for are gas water heaters. These are undoubtedly the preferred type. Listed here are a number of self diagnostic steps one can look at if the gas water heater is just not heating water in any way.

How to Self Diagnose a San Jose Gas Water Heater Repair

This will likely appear evident, nonetheless verify to be sure the gas to the water heater is switched on. Move the gas control knob to PILOT to hinder the burner from igniting while looking within. Take off the metal cover at the lower part of the water heater and take a look to check if the burner and the pilot light are ignited.

If the water heater’s pilot light has gone out, adhere to the information on the storage tank to relight it (we have the common methods to achieve this stated below). There does exist a chance that the gas inlet valve is shut to some extent or entirely. If that is the fact, simply turn the handle parallel to the line and igniate the pilot. If the pilot continue to not ignite, then the concern may perhaps be with the thermocouple. A good number of current water heaters possess a glow plug or spark ignitor rather then a pilot. Examine the owner’s info for a reference point.Gas Water Heater Repair San Jose

If the burner is not on, replace the cover and ensure that the thermostat is establish around 120 degrees F. If it is not, correct it, run on a hot water faucet in close proximity to the water heater, and after that wait around a little bit to check if the water heater burner ignites. If it doesn’t ignite, keep the hot water running and try out decreasing and then increasing the temperature setting on the dial until eventually the burner ignites.

Whenever the burner ignites, replace the cover and switch the thermostat once again to the proper setting. If the burner will not ignite, allow us to take a look at the water heater. The heater’s thermostat may very well be malfunctioning. A thermostat switch should really be executed by us.

Do you smell gas? If a smell a lot like garlic is recognized, switch the gas valve control to the OFF placement. Hang on and check if the gas odor is gone prior to relighting the pilot. If it does not pass, without delay switch off the gas supply valve, air out the area as best as is possible and phone the gas utility company.

Pilot Light Doesn’t Stay Lit

Attempt to relight the water heater initially. In fundamental terms, move the water heater’s gas valve to the OFF status then to the PILOT placement. Push the pilot button down to light it, and then hang on until a status light indicates the dial may be changed from PILOT to ON.

In the event that the pilot light continues going out, possibly the orifices might be unclean and blocked, that may make the flame too tiny to remain lit. Verify to ensure there is no evident dirt and debris clogging it.

In cases where everything appears to be clean, the situation may well be with the thermocouple. This is the piece that runs from the temperature control directly into the flame of a pilot light and facilitates the main burner fire up as soon as the water temperature has moved too low. The pilot light may be impacted if the thermocouple is flawed or fails to come into contact with the pilot flame. Various people may well feel safe changing a thermocouple, but Gas Water Heater Repair San Jose would rather you call us to help.

Decreased gas pressure or a not working gas control valve also can lead to a pilot light to go out often. Call us if you think that this is the condition.

26
Like
Save