Removing Sediment in Your San Antonio Water Heater

Removing Sediment in Your San Antonio Water Heater

If you have an issue with sediment, you’re probably currently familiar with it. Gas fired water heaters in particular frequently indicate that there is a sediment issue with rumbling sounds each time the tank cycles, while still keeping great water temperature. Fortunately, sediment in your hot water tank can easily be eliminated, preserving the functionality of your heater.

Water Heater Repair San Antonio

Water heater (Photo credit: km6xo)

If you have a gas water heater, turn the control to pilot. If you have an electric design, you ought to turn off the power at the panel. Next shut down the water above the heater so no brand-new water can get in the tank. Then connect a hose to the drain valve. The various other end of the hose should preferably go to a floor drain, although a bucket can also be made use of.

Open the drain valve to get rid of all the water from the tank. Most of the sediment needs to be eliminated by this easy act. Keep the drain valve open, but switch on the water as well, permitting some to get in the tank. Turn off the water after a couple of moments. Repeat this several times to coax as much sediment out with the water.

As a last procedure, close the drain and fill the tank a minimum of half full. Then you can drain it for a final time to get rid of any last remains of sediment. To avoid additional typical sediment issues, you can set up a sediment filter for your tank if your issue is mainly with sand. A sand filter need to be set up on the cold trunk line.

Often sediment can likewise congest up the drain valve itself. Preferably you ought to have the ability to wash the valve out under high pressure, but occasionally the valve should be replaced after a cleaning. You can achieve this job while the tank is still full, simply switch off the gas or power and await the water in the tank to cool. You must likewise not make use of any water in your house will finishing the replacement.

To eliminate the drain valve, merely utilize a large groove joint pair of pliers to turn off the old valve. Then set up a replacement valve by turning it in clockwise. Make certain to utilize pipe thread sealing tape or pipe joint substance on the threads to guarantee that the connection will prove out.

If you are planning to remove the drain valve, you could consider prior to setting up the replacement valve providing your tank a last flush. This is finest done if you have a floor drain that will rapidly drain the water and sediment.

Lots of people mistakenly think that a sediment filled tank or a leaky drain valve is cause to replace the entire hot water heater. By these simple upkeep steps, many property owners should be able to deal with any troubles on their own. Naturally, if you encounter various other issues while completing this repair, call a plumbing technician who will have the ability to easily attend to the problem.

Water Heater Repair San Antonio invites you to read more from us:

San Antonio Tankless Water Heater Repair Tips

Water Heater Replacement San Antonio

Enhanced by Zemanta
29
Like
Save